Manual Control Lever Shaft and Seal: Removal

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to JACKING & LIFTING .
Disconnect the selector lever cable end.

Fig 1: Locating Shift Cable End
Courtesy of FORD MOTOR CO.
Remove the transmission fluid pan, gasket and filter. For additional information, refer to FLUID PAN, GASKET AND FILTER .

NOTE: The pin should be driven up through the manual control lever.

Fig 2: Locating Manual Valve Detent Lever Shaft Retaining Pin

Courtesy of FORD MOTOR CO.

Remove and discard the manual control valve detent lever shaft retaining pin.
Using the Roll Pin Set, remove the manual control lever shaft retaining pin.

Fig 3: Removing Manual Valve Detent
Courtesy of FORD MOTOR CO.

NOTE: Be careful not to damage the manual control lever bore.

Fig 4: Locating Manual Control Lever Shaft Assembly

Courtesy of FORD MOTOR CO.

Remove the manual control lever shaft assembly.
Using the Pilot Bearing Remover, remove the manual control lever shaft seal and discard.

Fig 5: Removing Seal Retainer
Courtesy of FORD MOTOR CO.