LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2750 (Automatic Transmission - 5R110W (TORQSHIFT(R)) -- F250-F550 Super Duty) >> In-Vehicle Repair >> Internal Harness Service >> Removal

Internal Harness Service: Removal

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the solenoid body assembly. For additional information, refer to SOLENOID BODY ASSEMBLY .
  2. Disconnect the transmission internal harness.
    1. Remove the 2 screws.
    2. Disconnect the Transmission Fluid Temperature (TFT) sensor.
    3. Disconnect the solenoid connectors.
      Fig 1: Identifying Transmission Fluid Temperature (TFT) Sensor Connector And Screws
      G06140695Courtesy of FORD MOTOR CO.
  3. Remove the transmission internal harness connector O-ring seal.
    Fig 2: Locating Solenoid Body Connector O-Ring
    G06140696Courtesy of FORD MOTOR CO.
  4. Lift the tab. Twisting the transmission internal harness connector, push it through the solenoid body and remove the wire harness.
scientia non olet · About LEMON Manuals