Internal Harness Service: Installation

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Push the transmission internal harness connector through the transmission solenoid body, twist it to lock it in place.
Connect the transmission internal harness.
1. Install the 2 screws.
2. Connect the TFT sensor.
3. Connect the solenoid connectors.
  
  Fig 1: Identifying Transmission Fluid Temperature (TFT) Sensor Connector And Screws
  Courtesy of FORD MOTOR CO.

NOTE: The O-ring seal must be installed in the top slot.

Fig 2: Locating Solenoid Body Connector O-Ring

Courtesy of FORD MOTOR CO.

Install a new solenoid body transmission internal harness connector O-ring seal and lubricate it with automatic transmission fluid.
Install the solenoid body assembly. For additional information, refer to SOLENOID BODY ASSEMBLY .