Extension Housing Seal: Removal

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Remove the driveshaft. For additional information, refer to DRIVESHAFT .
Four-Wheel Drive (4WD) vehicles
Remove the transfer case. For additional information, refer to TRANSFER CASE .
Transmissions with a fixed flange
Remove the output shaft flange.
1. Remove and discard the output shaft flange bolt.
2. Remove the output shaft flange.
  
  Fig 1: Identifying Output Shaft Flange Bolt
  Courtesy of FORD MOTOR CO.
Using the Output Shaft Locknut Socket, remove and discard the output shaft nut.

Fig 2: Identifying Output Shaft Locknut Socket
Courtesy of FORD MOTOR CO.
Using the Transmission Extension Housing Seal Remover along with the Torque Converter Fluid Seal Remover and Slide Hammer, remove the output shaft seal.

Fig 3: Identifying Output Shaft Seal
Courtesy of FORD MOTOR CO.

Transmissions without a fixed flange
Using the Transmission Extension Housing Seal Remover along with the Torque Converter Fluid Seal Remover and Slide Hammer, remove the extension housing seal.

Fig 4: Removing Extension Housing Seal
Courtesy of FORD MOTOR CO.