Special Tool(s)

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOLS CHART

Courtesy of FORD MOTOR CO.	Aligner, Clutch Spring Compressor 307-455
Courtesy of FORD MOTOR CO.	Compressor, Clutch Spring 307-015 (T65L-77515-A)
Courtesy of FORD MOTOR CO.	Fixture Body, Coast Clutch 307-385
Courtesy of FORD MOTOR CO.	Fixture Handle, Coast Clutch 307-384
Courtesy of FORD MOTOR CO.	Handle 205-153 (T80T-4000-W)
Courtesy of FORD MOTOR CO.	Handle, Torque Converter 307-091 (T81P-7902-C
Courtesy of FORD MOTOR CO.	Loading Fixture, Clutch 307-S383
Courtesy of FORD MOTOR CO.	Remover, Output Shaft Seal/Housing 307-460
Courtesy of FORD MOTOR CO.	Remover, Pilot Bearing 308-001 (T58L-101-B)
Courtesy of FORD MOTOR CO.	Remover, Torque Converter Fluid Seal 307-309 (T94P-77001-BH) (used with 100-001)
Courtesy of FORD MOTOR CO.	Remover, Transmission Extension Housing Seal 307-454 (used with 307-309)
Courtesy of FORD MOTOR CO.	Remover, Transmission Fluid Pump 307-221 (T89T-70010-A)
Courtesy of FORD MOTOR CO.	Retaining Ring Pliers 307-343 (T95P-77001-AHR)
Courtesy of FORD MOTOR CO.	Retainer, Torque Converter 307-346 (T97T-7902-A)
Courtesy of FORD MOTOR CO.	Roll Pin Set 211-S060 (T78P-3504-N)
Courtesy of FORD MOTOR CO.	Slide Hammer 100-001 (T50T-100-A)
Courtesy of FORD MOTOR CO.	Socket, Output Shaft Locknut 307-458