No Reverse Only

WARNING: This page is about a different car, the 2010 Ford Pickup, 2010 Ford F550 Super Duty, 2010 Ford F450 Super Duty, and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

DIAGNOSTIC ROUTINES - NO REVERSE ONLY

Possible Component	Reference/Action
202 - ROUTINE
Powertrain Control System
PCM (gasoline engines), Transmission Control Module (TCM) (diesel engines), external vehicle wiring harnesses, transmission internal harness, Pressure Control Solenoid A (PCA)	Carry out On-Board Diagnostic (OBD) tests. Refer to the INTRODUCTION - GASOLINE MODELS for diagnosis and testing of the PCM. For gasoline engines, GO to PINPOINT TEST E . For diesel engines, GO to PINPOINT TEST J . Repair as required. Clear the DTCs, road test and carry out OBD test.
Selector Lever Cable
Cable system damaged, misaligned	Inspect and repair as necessary. Refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
Incorrect Line Pressure
Low pressure	Check pressure at line tap. Carry out Line Pressure Test. Refer to SPECIAL TESTING PROCEDURES . Follow the pressure diagnosis test as required.
Solenoid Body Assembly
Bolts not tightened to specification	Tighten to specification.
Filter gasket damaged, blown out, leaking	Inspect for damage. If damaged, install a new filter gasket.
Contamination	Disassemble and clean.
PCA damaged, stuck or bore damaged. Manual valve damaged, stuck or bore damaged	If damaged or parts are missing, install a new PCA or solenoid body assembly. If misassembled, reassemble correctly.
Center Support
Feedbolt not tightened to specification	Tighten to specification.
Direct clutch seal rings or bearing damaged	Inspect for damage. Repair as necessary.
Support damaged or leaking	Inspect for damage. Repair as necessary.
Low/Reverse Clutch Assembly
Seals, piston damaged	Inspect for damage. Repair as necessary.
Filtered orifice damaged, missing, not seating, off location	Inspect for mislocation, poor seating, damage. Install a new case if damaged.
Friction elements damaged or worn	Inspect for damage. Repair as necessary.
Return spring damaged	Inspect for damage. Repair as necessary.
Snap ring for One-Way Clutch (OWC) and/or return spring not seated or damaged	Inspect for damage. Repair as necessary.