Valve Seals: Installation

All valve seals 

NOTE: Lubricate the valve seal and valve stem with clean engine oil prior to installation.
1. Position a new valve seal onto the valve stem.
2. Using the Valve Stem Oil Seal Installer, install the new valve seal.
   Fig 1: Installing Valve Seal Using Special Tool

   Courtesy of FORD MOTOR CO.
NOTE: If the components are to be reinstalled, they must be installed in the same positions. Failure to follow these instructions may result in engine damage.
Fig 2: Installing Valve Spring Retainer Keys
Courtesy of FORD MOTOR CO.
3. Using the Valve Spring Compressor, install the valve spring, the valve spring retainer and the valve spring retainer keys.
4. Relieve the air pressure from the cylinder.
NOTE: If the components are to be reinstalled, they must be installed in the same positions. Failure to follow these instructions may result in engine damage.
NOTE: Do not allow the valve keepers to fall off of the valve or the valve may drop into the cylinder. If a valve drops into the cylinder, the cylinder head must be removed. For additional information, refer to CYLINDER HEAD .
NOTE: It may be necessary to push the valve down while compressing the spring.
NOTE: Lubricate the camshaft roller followers with clean engine oil prior to installation.
Fig 3: Installing Camshaft Roller Followers
Courtesy of FORD MOTOR CO.
5. Using the Valve Spring Compressor, compress the valve spring and install the camshaft roller follower.
6. Install the spark plug. For additional information, refer to ENGINE IGNITION - 5.4L AND 6.8L (3V) .

   LH cylinder head valve seals 

7. Install the LH valve cover. For additional information, refer to VALVE COVER - LH .

   RH cylinder head valve seals 

8. Install the RH valve cover. For additional information, refer to VALVE COVER - RH .