Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2010 Ford Pickup and 2010 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Press the position retaining tabs and rotate the lower cooling fan shroud upward until the position retainer tab locks into position.

Fig 1: Positioning Retainer Tab Locks
Courtesy of FORD MOTOR CO.
Rotate the tensioner clockwise and remove the accessory drive belt.

Fig 2: Removing Accessory Drive Belt
Courtesy of FORD MOTOR CO.
Remove the crankshaft pulley bolt and washer.
- Discard the crankshaft pulley bolt.
Using the 3 Jaw Puller, remove the crankshaft pulley.

Fig 3: Removing Crankshaft Pulley Using Jaw Puller
Courtesy of FORD MOTOR CO.