Crankshaft Pulley: Removal

WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Press the position retaining tabs and rotate the lower cooling fan shroud upward until the position retainer tab locks into position.

Fig 1: Pressing Position Retaining Tabs & Rotating Lower Cooling Fan Shroud Upward Until Position Retainer Tab Locks Into Position

Courtesy of FORD MOTOR CO.

Rotate the tensioner clockwise and remove the accessory drive belt.

Fig 2: Rotating Tensioner Clockwise

Courtesy of FORD MOTOR CO.

Remove the crankshaft pulley bolt and washer.
- Discard the crankshaft pulley bolt.
Using the Crankshaft Vibration Damper Remover, remove the crankshaft pulley.

Fig 3: Removing Crankshaft Pulley Using Special Tool (303-009)

Courtesy of FORD MOTOR CO.