LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2346 (Front Suspension - Rear Wheel Drive (RWD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Bearing And Wheel Hub - F250, F350 >> Removal

Wheel Bearing And Wheel Hub - F250, F350: Removal

WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    2. CAUTION: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.
  2. Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
    • Support the brake caliper and anchor plate assembly using mechanic's wire.
  3. Remove the grease cap.
  4. Remove the cotter pin, wheel spindle nut retainer, nut and flat washer.
    • Discard the wheel spindle nut.
    5. NOTE: Inspect the condition of the wheel spindle and threads, clean or install new components as necessary.
  5. Remove the outer wheel bearing, then remove the brake disc and hub assembly.
    6. CAUTION: Do not damage the wheel bearing cage while removing. A damaged wheel bearing cage may cause premature bearing failure.
  6. Using a suitable slide hammer and bearing seal remover, remove the inner wheel bearing seal and bearing.
scientia non olet · About LEMON Manuals