LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> eSprinter Base, _NA_ >> Repair and Diagnosis >> External Pages >> Different car >> Section 2339 (Transfer Case - Four-Wheel Drive (4WD) System - Diagnostics -- F250-F550 Super Duty) >> Diagnostic Tests >> Four Wheel Drive (4WD) Systems - Electronic Shift >> Pinpoint Tests >> Pinpoint Test M: The 4WD System Jumps Out of Gear >> Pinpoint Test M: The 4WD System Jumps Out Of Gear

Pinpoint Test M: The 4WD System Jumps Out Of Gear

WARNING: This page is about a different car, the 2009 Ford Pickup, 2009 Ford F550 Super Duty, 2009 Ford F450 Super Duty, and 2009 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. M1 VERIFY THE CONCERN 
    • Drive the vehicle and attempt to duplicate the concern.
    • Is the concern an uncommanded mode shift (in or out of 4X4 Low)? 
    1. YES  : Go to  M4.
    2. NO  : Go to  M2.
  2. M2 CHECK THE MODE SELECT SWITCH (MSS) POSITION PIDs 
    • Key in OFF position.
    • Connect the scan tool.
    • Key in ON position.
    • Drive the vehicle.
    • Dynamically monitor the MSS PID 4WD_SW while driving the vehicle in each shift position.
    • Does the MSS PID always agree with the MSS position? 
    1. YES  : Go to  M3.
    2. NO  : Go to Pinpoint Test I .
  3. M3 CHECK FOR DTCs 
    • Carry out the on-demand self test.
    • Are DTCs present? 
    1. YES  : REFER to the 4X4 Control Module DTC Chart.
    2. NO  : Go to Pinpoint Test P .
  4. M4 CHECK THE 4X4 INDICATORS 
    • With the vehicle rolling, shift the transmission to NEUTRAL.
    • Press the brake pedal.
    • Observe the 4X4 indicators in the instrument cluster (IC) while cycling through each MSS position.
    • Do the 4X4 indicators match MSS positions? 
    1. YES  : Go to  M2.
    2. NO  : Go to  M5.
  5. M5 CHECK FOR DTCs 
    • Transmission in park.
    • Release the brake pedal.
    • Carry out the on-demand self test.
    • Are DTCs present? 
    1. YES  : REFER to the 4X4 Control Module DTC Chart.
    2. NO  : CHECK the transfer case fluid level. REFER to TRANSFER CASE article. If the fluid level is OK, CHECK for internal transfer case faults. REFER to TRANSFER CASE article.
scientia non olet · About LEMON Manuals