LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> GLA250 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Sliding Roof, Soft Top, Top Attachments -- 118 Chassis) >> Testing & Repair >> Remove/Install Panoramic Sliding Roof Motor - AR77.21-P-6995MFA

Remove/Install Panoramic Sliding Roof Motor - AR77.21-P-6995MFA

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

Model 118, 177 

with code 413 (Automatic panoramic sliding sunroof) 

MODIFICATION NOTES

25.07.2019 Perform initial startup. Operation step 7.  

Shown on model 177.0 with code 413 (panoramic sliding sunroof) 

Fig 1: Panoramic Sliding Roof Motor Components Location - Model 118 With Code 413
G16063876WARNINGREMOVINGINSTALLINGNOTESREFER TO SELF DIAGNOSTIC SYSTEMSCourtesy of MERCEDES-BENZ USA
WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
Topical note  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REMOVINGINSTALLING Remove/install     
1 Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).    
2 Release roof lining in front area until panoramic sliding sunroof drive unit (M12) is accessible. Model 118.6 with code 413 (Automatic panoramic sliding sunroof) AR68.30-P-4300MFD
    Model 118.3, 177.1/9 with code 413 (Automatic panoramic sliding sunroof) AR68.30-P-4300MFV
    Model 177.0 with code 413 (Automatic panoramic sliding sunroof) AR68.30-P-4300MFA
3 Remove screws (1).    
4 Lower panoramic sliding sunroof drive unit (M12) until electrical connector (2) is accessible. NOTES
Do not crush or kink or subject electric lines to tension.
This will result in damage to the electric lines and can impair their function.
 
5 Release and disconnect electrical connector (2) and remove panoramic sliding sunroof drive unit (M12).    
6 Install in the reverse order.    
7 Normalize commissioning of panoramic sliding sunroof drive unit (M12) using diagnostic system and perform teach-in run for automatic reversing function. When replacing panoramic sliding sunroof drive unit (M12).  
REFER TO SELF DIAGNOSTIC SYSTEMS     AD00.00-P-2000-06MFA