LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2024 >> GLA250 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Collision - General Body Information - 118 Chassis) >> Body Repair General Information >> Guidelines For Removing Fuel Tank When Performing Welding Work On Bodies - Ah60.00-P-3000-01Z

Guidelines For Removing Fuel Tank When Performing Welding Work On Bodies - Ah60.00-P-3000-01Z

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.

All models

Model all (CAR, Light transporter) 

When repairing or partially replacing the listed parts scopes, the removal of the fuel tank is to be determined by a manager on a case-by-case basis, depending on the type and size of damage involved.

NOTES

On vehicles with an evaporative emission control system, if welding work is performed in the area of the feed line of the vent line or the activated charcoal canister, the system must be covered with a welding protection blanket or the system must be removed.

Removal of fuel tank when replacing: 

Seal airtight using SPECIAL TOOL (set of covers) and mount heat shield.

*As soon as the damage becomes more extensive and when welding work is required on the wheel well or on the rear pillar, the fuel tank must also be removed for these diesel models.

Remove tank filler neck with vent line