Remove/Install Retaining Lock For Crankshaft/Ring Gear - AR03.30-P-5000MFC
Engine 260 in model 118, 177, 247
Shown on model 177 without code M016 (performance-enhanced engine)
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Install/remove | |||
| 1 | Remove air filter housing. | AR09.10-P-1150MFC | |
| 2 | Remove battery carrier. | AR54.10-P-0028MFA | |
| 3.1 | Remove starter. | If retaining lock should be installed in installed transmission. Engine 260 in model 118, 177, 247 except code B01 (48V technology) |
AR15.30-P-7100MFC |
| 3.2 | Remove cover over starter opening. | Engine 260 in model 118, 177, 247 with code B01 (48V technology) If retaining lock should be installed in installed transmission. |
*BA15.30-P-1003-01J |
| 3.3 | Remove transmission. | If retaining lock should be installed in removed transmission. | |
| Engine 260 in model 118, 177, 247 with transmission 724.1 | AR01.10-P-2401MFJ | ||
| Engine 260 in model 118, 177, 247 with transmission 724.0 | AR01.10-P-2401MFC | ||
| 4.1 | Rotate the engine at the center bolt of the crankshaft in the direction of engine rotation and check the toothing of the starter ring gear (1) for wear or damage. | With installed transmission. | |
| Fig 3 | |||
| If there are problems: ↓ Replace drive plate. Engine 260 in model 118, 177, 247 with transmission 724.0 |
AR03.30-P-8001MFC | ||
| Engine 260 in model 118, 177, 247 with transmission 724.1 | AR03.30-P-8001MFI | ||
| 4.2 | Check the starter ring gear (1) for wear or damage. | With removed transmission. If there are problems: ↓ Replace drive plate. Engine 260 in model 118, 177, 247 with transmission 724.0 |
AR03.30-P-8001MFC |
| Engine 260 in model 118, 177, 247 with transmission 724.1 | AR03.30-P-8001MFI | ||
| 5.1 | Insert retaining lock (01) in starter opening until it engages with the starter ring gear (1). | With installed transmission. |
Fig 2 |
| 5.2 | Install the retaining lock (02) on the crankcase. | With removed transmission. |
Fig 1 |
| 6 | Removal in the reverse order. |
STARTER
| Number | Designation | Engine 260 | |
|---|---|---|---|
| BA15.30-P-1003-01J | Bolt, starter to crankcase/transmission | Nm | 38 |