Apply Sealant To Rear Cap On Cylinder Head - AR01.30-P-0002-01MFG
Engine 139 in model 118, 177, 247
- Apply the sealant at the specified sealant path in the form of a bead with a height and breadth of 2.0 mm (±0.5 mm).
The sealing surfaces must be cleaned.
The sealing surfaces must be flat (replace any bent component parts).
The line denotes the sealant path.
Use only the sealant listed in the repair products.
The sealant bead must be continuous with no interruptions.
Do not spread the sealant bead.
Maximum assembly time:
10 minutes
Once the parts have been assembled, do not disassemble them again.