Remove/Install Rear Window Frame Lining For Rear Window In Side Wall - Ar68.30-D-0026TSR

Model 907.6/7 

Shown on model 907.7 on the left side of the vehicle with code IR4 (wheelbase 3,665 mm), with code V21 (luxury interior trim), with code EL9 (2-way front and rear speaker system) and except code T19 (left sliding door) for removed passenger bench seats 

	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Remove/install
1	Remove D-pillar trim (2).		AR68.30-D-4497TSR
2	Release edge guard (3) in the area of the window frame lining (1).
3	Lift window frame lining (1), pry off, and remove.	: Ensure that the window frame lining (1) overlaps the window frame linings (4, 5). The window frame lining (1) is bonded to the side wall using tape.
		Long wedge	Fig 1
4	Remove masking tape residues from the side wall with a suitable tool.	Cleaner	*BR00.45-Z-1025-04A
5	Remove masking tape residues from the window frame lining (1) with a suitable tool.	When reusing the window frame lining (1).
		Cleaner	*BR00.45-Z-1025-04A
6	Attach new adhesive tape strips to the window frame lining (1).	When reusing the window frame lining (1). Ensure that the adhesive strips are positioned in the same way as the adhesive strips that were removed previously. Otherwise adhesion problems may occur.
		Double-sided tape with polyethylene foam support, Scotch-Mount 9528	*BR00.45-Z-1197-02A
7	Install in the reverse order

Fig 1: Long Wedge (115 589 03 59 00)