Remove/Install Brake Light Switch - Ar42.10-D-0042TS

Model 907 

	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Remove
1	Disconnect electrical connector of brake light switch (1).
2	Remove brake light switch (1) from retaining clip (2).	To do so, press out brake light switch (1) toward rear.
3	Remove retaining clip (2) from holder (3).	To do so, press together locks at side.
	Install
4	Attach retaining clip (2) to holder (3).	Check retaining clip (2) for damage. If corresponding findings are present, ↓ replace brake light switch (1).
5	Connect electrical connector of brake light switch (1).
6	Install brake light switch (1) into retaining clip (2).
7	Adjust air gap (arrow).	To do so, position feeler gauge between brake light switch (1) and sensor plate (4) of brake pedal. It must be possible to move the feeler gauge snugly between the two components. Commercially available devices/tools  Feeler gage Do not operate brake pedal. Clearance between brake lights switch and brake pedal sensor plate If the feeler gauge cannot be positioned snugly: ↓ Slide brake light switch (1) backwards or forwards by an engagement and reposition feeler gauge between brake light switch (1) and sensor plate (4) of brake pedal.	*BE42.10-N-1019-10A

TEST AND ADJUSTMENT VALUES FOR SERVICE BRAKE

Number	Designation		Model 907
BE42.10-N-1019-10A	Clearance between brake lights switch and brake pedal sensor plate	mm	1