Confirm Vehicle Handover On Display - AP00.20-D-0041-01TS

Model 907 

with code C6L (Multifunction steering wheel) 

1. Close hood, doors and sliding doors.
2. Switch electronic ignition lock control unit (EZS) to position "1" (circuit 15R).
3. Using swipe movements on the finger navigation pad (2) to select the "Total distance" standard display in the multifunction display (3).
4. Press and hold "Back" (1) button for 2 s and press on finger navigation pad (2).

   The multifunction display (3) then shows the Workshop menu with the menu items: "Vehicle data", "Dynamometer test", "Change brakepad", "ASSYST PLUS".

5. Use swipe movements on the finger navigation pad (2) to select and confirm the "ASSYST PLUS" menu item.
6. Switch electronic ignition lock control unit (EZS) to position "2" (circuit 15R).

   The multifunction display (3) then shows the menu items: "Service data", "Full service", "Vehicle handover" (if not yet conducted), "Engine oil level measurement".

7. Use swipe movements on the finger navigation pad (2) to select and confirm the "Vehicle handover" menu item.

   The multifunction display (3) then shows the prompt "Handover vehicle?" and the menu items "No", "Yes".

8. Use swipe movements on the finger navigation pad (2) to select and confirm the "Yes" menu item.

   The vehicle can be handed over up to a driven distance of 500 km.

9. Press "Back" (1) button repeatedly until the "Total distance" standard display appears in the multifunction display (3).