Remove/Install Load Compartment Floor - Ar68.80-D-5800TSF

Model 907.6 

with code VK8 (Floor covering, plastic) 

except code V43 (Wood flooring) 

Shown on model 910.6 with code Y26 (Chock) 

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Remove/install
1	Remove rail (1).
2	Remove bracket (2) for chock.	Model 907.6 with code Y26 (Chock)
3	Remove screws (3) and washers (4) with spacer sleeves.
4	Remove screws (5) and remove tie-down eyes (6) with handle recess shells (7) and spacer sleeves.	The number of tie-down eyes (6) may vary depending on the vehicle equipment.
		Screw, tie-down eye to load compartment floor	*BA68.50-D-1002-03TS
5	Remove screws (8) and remove tie-down eyes (9) with handle recess shells (10) and spacer sleeves.	The number of tie-down eyes (9) may vary depending on the vehicle equipment.
		Screw, tie-down eye to load compartment floor	*BA68.50-D-1002-03TS
6	Carefully disconnect load compartment floor (12) from Velcro strips (arrows) and remove to the rear.	Helper required.
7	Install in the reverse order.

CARGO RETAINERS