Remove/Install Inside Rearview Mirror - Ar68.40-D-0001TS
Model 907
Shown with code FR3 (Reversing camera with inside rearview mirror display)
| Risk of injury caused by irritation of the skin, eyes and respiratory system through contact or inhalation of substances contained in the mirror lens. | Wear protective gloves and safety glasses. | AS60.00-Z-0008-01R | |
| Notes on carrying out repair work in the vehicle interior | AH68.00-N-0001-01S | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | Model 907 with code FR3 (Reversing camera inside rearview mirror display) |
|
| 2 | Unclip cover (2) and remove from trim (3) | Clip remover | Fig 1 |
| 3 | Unclip and remove cover (3) | Fig 1 | |
| 4 | Disconnect electrical connection (4) | Model 907 with code FR3 (Reversing camera inside rearview mirror display) |
|
| 5 | Turn inside rearview mirror (1) at mirror base (5) towards right approx. 45° using an open-end wrench and remove from mirror bracket | ||
| 6 | Install in the reverse order | ||
| Check | |||
| 7 | Perform function test of reversing camera with inside rearview mirror display | Model 907 with code FR3 (Reversing camera inside rearview mirror display) |