Subsequently Fasten Wiring Harness For HERMES Pre-Installation (Code: Vs3HERLEIT, Acc. No.: 54 918 84) - SM54.18-D-0082SG

Model 907with code JH6 (Pre-installation for communications module for digital services (LTE)) 

Routing of HERMES preinstallation wiring harness (1) 

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on carrying out repair work in the vehicle interior		AH68.00-N-0001-01S
	Check
1	Check whether vehicle is affected by measure.	Affected vehicles: Subsequently fasten wiring harness for HERMES pre-installation (code: VS3HERLEIT, acc. no.: 54 918 84) Model 907.### #N as of 000828 up to 052352 with code JH6 (Pre-installation for communications module for digital services (LTE)) Model 907.### #P as of 001327 up to 146816 with code JH6 (Pre-installation for communications module for digital services (LTE)) Model 907.### #T as of 000397 up to 011342 with code JH6 (Pre-installation for communications module for digital services (LTE))	SM54.18-D-0084-01AAA
		For authorized Mercedes-Benz service partners, only the entry in the Extended VEGA Application (EVA) system, in the "Current" tab is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.
2	Check routing of HERMES pre-installation wiring harness (1).	Make sure that the HERMES preinstallation wiring harness (1) and the plugs (2) are not trapped between the brake pedal (3) and the brake light switch.
	Retrofit Hermes preinstallation wiring harness (1)
3	Retrofit HERMES preinstallation wiring harness (1).	To do so, fasten HERMES preinstallation wiring harness (1) to existing electrical wiring harness using a cable tie. Fasten HERMES preinstallation wiring harness (1) in such a way that no plug (2) or electric lines can be trapped between the brake pedal (3) and the brake light switch. The openings of the plugs must face downwards.