Code Signal Acquisition And Actuation Module (Code: Vs3FLACKHL, Acc. No.: 82 920 70) - SM54.21-D-0134SG

Model 907.6##/7## #P as of 000484 up to 003358 

Operation no. of the operation texts or standard texts and flat rates
Category	Op. no.	Operation text	Time	Acc. no.	Code
L	02 2330	Operations: Perform SCN coding in signal acquisition and actuation module (SAM) control unit	-	82 920 70	VS3FLACKHL

	Notes on SCN coding of control units		AH54.21-P-0004-01X
	Check
1	Check whether vehicle is affected by measure.	Affected vehicles: Code signal acquisition and actuation module (Code: VS3FLACKHL, Acc. no.: 82 920 70)
		Affected vehicles: Code signal acquisition and actuation module (Code: VS3FLACKHL, Acc. no.: 82 920 70) Model 907.6##/7## #P as of 000484 up to 003358 For authorized Mercedes-Benz service partners, only the entry in the Extended VEGA Application (EVA) edition, in the "Current" tab is decisive. An additional test of the affected vehicles in the workshop information system (WIS) or vehicle list is thereby not necessary.	SM54.21-D-0134-01AAA
	SCN coding
2	Connect charging equipment.
	000 588 00 81 00 Charger	During the entire work procedure a sufficiently large voltage supply must be provided for the vehicle's on-board electrical system. Otherwise any undervoltage that occurs may damage the control units. Follow the operating instructions for the charger. Use the charger to ensure that an adequate power supply (min. 12.5 V) is provided for the on-board electrical system battery.	WS54.00-P-0037B
3	Connect diagnostic system.
			AD00.00-D-2000-06TS
4	Perform SCN coding in signal acquisition and actuation module (SAM) control unit.	See process description in diagnostic system "INFO".
5	Disconnect diagnostic system.
			AD00.00-D-2000-06TS
6	Remove charger from vehicle.