Removing Rear Head Restraint - AR91.16-P-1770MEM

Model 167.9 

With Code M036 (Maybach Version) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Remove/install
1	Remove backrest in rear passenger compartment.		AR91.12-P-1713MEM
2	Remove expansion rivets (3) from seat backrest trim (2).	Dismantling tool	Fig 1
3	Unhook seat backrest trim (2) and remove.
4	Remove clip (6) from left and right mount (arrows) of holder (7).	Ensure head restraint struts (4) are seated correctly in mounts (arrows) of holder (7).
5	Disconnect electrical connector (5).
6	Pull head restraint (1) with wiring harness of electrical connector (5) upward out of head restraint guides and remove.	Guide electrical connector (5) and wiring harness out through head restraint guide.
7	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA