 |
Risk of injury
caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. |
No parts of the body or limbs should be within the operating area when the components are moving. |
AS00.00-Z-0011-01A |
| Topical note |
Information on preventing damage to electronic components due to electrostatic discharge |
|
AH54.00-P-0001-01A |
  |
Remove/install |
|
|
| 1 |
Remove left or right outside mirror trim. |
|
AR88.70-P-9040ME |
| 2 |
Remove screw/bolt (2). |
|
|
| 3 |
Remove telephone antenna (A2/102 or A2/103). |
Model 167 with code 274 (Telephone antenna) |
AR82.62-P-0011ME |
| 4 |
Remove ambient lamp (1) until the electrical connector is accessible. |
Ensure that the ambient lamp (1) is correctly seated in the guide (arrow). |
|
| 5 |
Release and disconnect electrical connector from ambient lamp (1). |
|
|
| 6 |
Install in the reverse order. |
|
|