Remove/Install Fan For Headlamp Unit - AR82.10-P-4742ME
Model 167
Shown on headlamp With Code 640 (SAE dynamic LED headlamp, right-hand traffic), With Code 641 (Dynamic LED headlamp, left-hand traffic), With Code 642 (Dynamic LED headlamp, right-hand traffic)
Shown on headlamp With Code 632 (Static LED headlamp, right-hand traffic)
Shown on headlamp With Code 632 (Static LED headlamp, right-hand traffic) with cover (2)
| Topical note | Note on damage to lamp unit | AH82.10-P-0002-00LW | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove | |||
| 1 | Remove front lamp unit (E1 or E2) and lay down on suitable base. | AR82.10-P-4733ME | |
| Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics | Wear protective gloves and safety glasses. Ensure that the work area is adequately ventilated. | AS00.00-Z-0001-02A | |
| 2.1 | Cut housing (1) of front lamp unit (E1 or E2) along the embossing (arrows A) with the hot knife. | Model 167 with code 632 (Headlamps, LED, static, right-side traffic) If the cover (2) is not installed. |
|
| 000 588 03 84 00 Hot knife | Otherwise electric lines will get damaged. |
WS82.00-P-0026B | |
| 2.2 | Remove cover (2). | Model 167 with code 632 (Headlamps, LED, static, right-side traffic) If the cover (2) is installed. |
|
| 2.3 | Remove front LED matrix lamp unit control unit (E1n11 or E2n11). | Model 167 with code 640 (SAE dynamic LED headlamps right-hand traffic) Model 167 with code 641 (Dynamic LED headlamps, left-hand traffic) Model 167 with code 642 (Dynamic LED headlamps, right-hand traffic) |
AR82.10-P-2025ME |
| 3 | Remove screws (3) and remove front lamp unit fan motor 1 (E1m4 or E2m4) from front lamp unit (E1 or E2) until the electrical connector (4) is accessible. | ||
| 4 | Release and disconnect electrical connector (4) and guide front lamp unit fan motor 1 (E1m4 or E2m4) out of housing (1). | ||
| Install | |||
| 5 | Insert front lamp unit fan motor 1 (E1m4 or E2m4) into housing (1) and tighten screws (3). | ||
| 6 | Connect electrical connector (4) to front lamp unit fan motor 1 (E1m4 or E2m4) and route wiring harness. | ||
| 7.1 | Install cover (2). | Model 167 with code 632 (Headlamps, LED, static, right-side traffic) | |
| 7.2 | Install front LED matrix lamp unit control unit | Model 167 (E1n11 or E2n11). with code 640 (SAE dynamic LED headlamps right-hand traffic) Model 167 with code 641 (Dynamic LED headlamps, left-hand traffic) Model 167 with code 642 (Dynamic LED headlamps, right-hand traffic) |
AR82.10-P-2025ME |
| 8 | Install front lamp unit (E1 or E2). | AR82.10-P-4733ME |