Remove/Install Side Step - AR88.30-P-2400ME
Model 167
With Code M036 (Maybach version)
Shown on right side of vehicle
Shown on right side of vehicle
Shown on rear mounting support (5) on right side of vehicle
Shown on rear mounting support (5) on right side of vehicle
| Risk of injury . Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | AS00.00-Z-0009-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Remove | |||
| 1 | Deactivate running boards (1) via the head unit. | ||
| 2 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 3 | Remove covers (2, 3). | Fig 1 | |
| 4 | Remove screw (6) until running board (1) can be extended manually. | ||
| 5 | Extend running board (1) manually. | ||
| 6 | Remove screws (7). | ||
| 7 | Detach running board (1) from mounting supports (4, 5) and remove. | ||
| 8 | Disconnect electrical connector (8). | ||
| 9 | Remove retaining clip (9). | Fig 1 | |
| 10 | Remove nuts (10) from mounting supports (4, 5). | ||
| 11 | Remove screws (11) on mounting supports (4, 5) and remove mounting supports (4, 5). | ||
| 12 | Remove drop bolts (12) from body. | ||
| Install | |||
| 13 | Position screws (11) on mounting supports (4, 5) and install drop bolts (12) vertically, as shown. | ||
| 14 | Install mounting supports (4, 5) together with screws (11) and drop bolts (12). | ||
| 15 | Position suitable assembly tool for screws and nuts on screws (11) and tighten in joining direction, applying constant pressure. | *BA88.30-P-1001-03B | |
| 16 | Attach nuts (10). | ||
| 17 | Install retaining clip (9). | ||
| 18 | Connect electrical connector (8). | ||
| 19 | Insert running board (1) in mounting supports (4, 5). | ||
| 20 | Position screws (7). | ||
| 21 | Retract running board (1) completely by hand and align in center. | ||
| 22 | Tighten bolts (7). | ||
| 23 | Tighten screw (6) while running board (1) is retracted. | ||
| 24 | Install covers (2, 3). | ||
| 25 | Activate running boards (1) via the head unit. |
RUNNING BOARD
| Number | Designation | Model 167 with code M036 (Maybach version) | ||
|---|---|---|---|---|
| BA88.30-P-1001-03B | Bolt, mounting console to body | Stage 1 | Nm | 5 |
| Stage 2: Loosen | ∠° | 720-1080 | ||
| Stage 3: Waiting time | s | 1-2 | ||
| Stage 4 | Nm | 10 | ||
| Stage 5 | Nm | 40 | ||