Remove/Install Augmented Reality Camera - AR54.30-P-0004ME
Model 167
With Code 21U (Video recording function (Dashcam))
Model 167
With Code U19 (Augmented reality video)
| Topical note | Information on preventing damage to | AH54.00-P-0001-01A | |
| electronic components due to electrostatic discharge | |||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Unclip inner cover (1) from inside rearview mirror using suitable tool (arrows A) and remove to rear. | ||
| 3 | Slide outer cover (2) on inside rearview mirror forward out of guides (arrow B). | ||
| 4 | Follow electric lines of augmented reality camera (B84/14) then release and disconnect electrical connector. |
||
| 5 | Unclip retaining clamp (3) of augmented reality camera (B84/14) from holder then remove augmented reality camera (B84/14). | Do not touch the lens of the augmented reality camera (B84/14). Otherwise, soiling could lead to an augmented reality camera (B84/14) malfunction. |
|
| 6 | Install in the reverse order. | ||
| 7.1 | Commission augmented reality camera (B84/14). | If the augmented reality camera (B84/14) was replaced. | |
| AD00.00-P-2000-06ME | |||
| 000 588 11 21 00 Adjustment device | WS82.00-P-0151B | ||
| 000 588 00 23 00 Adjusting gauge | WS82.00-P-0028B | ||
| 7.2 | Calibrate augmented reality camera (B84/14). | If the head unit (A26/17) was replaced or if the camera position was changed (e.g. lens replacement, removal of augmented reality camera (B84/14)). |
|
| AD00.00-P-2000-06ME | |||
| 000 588 11 21 00 Adjustment device | WS82.00-P-0151B | ||
| 000 588 00 23 00 Adjusting gauge | WS82.00-P-0028B |