Remove/Install Boost Pressure Control Flap Actuator - AR09.50-P-8845MRH
Engine 264
MODIFICATION NOTES
| 14.09.2021 | Basic date, added. | Operation step 5 |
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove upper engine cover. | Engine 264 in model 222 | AR01.10-P-2405MRJ |
| Engine 264 in model 213, 238, 257 | AR01.10-P-2405MRH | ||
| Engine 264 in model 205, 253 | AR01.10-P-2405MRI | ||
| Engine 264 in model 167 | AR01.10-P-2405MRK | ||
| 2 | Remove heat shield of exhaust gas turbocharger (1). | *BA09.40-P-1013-02C | |
| 3 | Release and disconnect electrical connector (4). | ||
| 4 | Remove clip (2). | ||
| 5 | Remove screws (5). | ||
| *BA09.40-P-1016-02C | |||
| 6 | Unhook actuator lever (3) and remove boost pressure control flap actuator (M16/7). | ||
| 7 | Install in the reverse order. | ||
| 8 | Connect vehicle diagnosis system, read out fault memory, and delete. | ||
| Engine 264 in model 167 | AD00.00-P-2000-06ME | ||
| Engine 264 in model 205, 213, 222, 253 | AD00.00-P-2000-04B | ||
| Engine 264 in model 257 | AD00.00-P-2000-06FR | ||
| Engine 264 in model 238 | AD00.00-P-2000-06LWO | ||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 9 | Perform engine test run and check engine for proper operation. |
TURBOCHARGER
| Number | Designation | Engine 264 | |
|---|---|---|---|
| BA09.40-P-1013-02C | Screw/bolt, heat shield to cylinder head | Nm | 9 |
TURBOCHARGER
| Number | Designation | Engine 264 | |
|---|---|---|---|
| BA09.40-P-1016-02C | Screw, boost pressure control flap actuator to exhaust gas turbocharger | Nm | 3 |