Remove/Install Low-Temperature Circuit Coolant Expansion Reservoir Holder - AR09.41-P-0017MNP
Engine 177 In Model 167
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Remove/install | |||
| 1 | Remove low-temperature circuit expansion reservoir upwards out of the elastomer bearings and place with attached lines to one side. | AR09.41-P-0001MNP | |
| 2 | Remove screws (2) from bracket (1). | *BA09.41-P-1019-01X | |
| 3 | Unscrew screw (3) from bracket (1). | *BA09.41-P-1020-01X | |
| 4 | Pull the bracket (1) out upwards. | ||
| 5 | Install in the reverse order. |
CHARGE AIR LINE/CHARGE AIR COOLING
| Number | Designation | Engine 177 | ||
|---|---|---|---|---|
| BA09.41-P-1019-01X | Screw, low-temperature circuit expansion reservoir bracket to cylinder head cover/heat shield | M6 | Nm | 8 |
CHARGE AIR LINE/CHARGE AIR COOLING
| Number | Designation | Engine 177 | ||
|---|---|---|---|---|
| BA09.41-P-1020-01X | Screw, low-temperature circuit expansion reservoir bracket to pressure sensor holder | M6 | Nm | 8 |