Remove/Install Charge Air Pressure And Temperature Sensor Downstream Of Throttle Valve - AR09.41-P-2012MRK

Engine 264 In Model 167 

Fig 1: Charge Air Pressure And Temperature Sensor Downstream Of Throttle Valve Components Location - Engine 264 In Model 167

Courtesy of MERCEDES-BENZ USA

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
Topical note	Notes on avoiding damage through contamination and foreign objects		AH00.00-P-5000-01A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Remove center and rear sections of lower engine compartment lining.		AR61.20-P-1105ME
3	Remove screws (3) at cable duct (4), unclip cable duct (4) and place to one side.		AH00.00-P-0007-01SF
Topical note	Notes on bolted connections with self tapping screws	Do not crush or kink or subject lines to tension This would lead to damage to the lines and can impair their function. : Ensure bracket (5) is correctly seated. Screw, cable duct to transmission bell housing	*BA27.10-P-1029-04H
4	Release electrical connector (1) and disconnect.
5	Remove screw/bolt (2).	Bolt, pressure sensor to charge air distributor	*BA09.20-P-1002-01H
6	Remove pressure and temperature sensor downstream of throttle valve (B28/27) and sea opening with suitable stop plug.	Record plug	Fig 2
7	Install in the reverse order
8	Connect vehicle diagnosis system, read out fault memory and clear if necessary.
			AD00.00-P-2000-06ME

INTAKE MANIFOLD

Number	Designation		Engine 264
BA09.20-P-1002-01H	Bolt, pressure sensor to charge air distributor	Nm	6

AUTOMATIC TRANSMISSION COMPLETE

Number	Designation		Transmission 725.0
BA27.10-P-1029-04H	Screw, cable duct to transmission bell housing	Nm	12

Fig 2: Identifying Record Plug (129 589 00 91 00)

Courtesy of MERCEDES-BENZ USA