Center Roof Paneling Installation - Ar65.10-P-1000-07MEC

Model 167.3 

except code 413 (Automatic panoramic sliding sunroof) 

Fig 1: Set Of Spacer Blocks (216 589 02 23 00)

Courtesy of MERCEDES-BENZ USA

The following operation steps are shown on model 167.3 except code 414 (Sliding roof).

The higher-level service document as well as the safety information in the service document must be observed.

1. Install center roof paneling (1), fit with set of spacer blocks and fix in place.

   When removing, observe specified dimensions and positions of set of spacer blocks.

2. Drill out rivet holes in center roof paneling (1) with Ø 6.7 mm (areas A).
3. Remove center roof paneling (1).
4. Deburr rivet holes on center roof paneling (1) and body on both sides.
5. Remove drilling chips.

   Courtesy of MERCEDES-BENZ USA

6. Apply anti-flutter adhesive to roof frame (areas B).

   Observe processing specification for relining adhesive.

7. Apply 2-component adhesive on body in cross-hatched areas (areas C).

   Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive.

   Courtesy of MERCEDES-BENZ USA

8. Apply lining adhesive to roof frame (areas D).

   Observe processing specification for relining adhesive.

   Courtesy of MERCEDES-BENZ USA

9. Install center roof paneling (1), fit with set of spacer blocks and fix in place.

   When removing, observe specified dimensions and positions of set of spacer blocks.

10. Rivet center roof paneling (1) with rivet Ø 6.5x12.5 (areas E).
11. Rivet center roof paneling (1) with rivet Ø 6.4x12 (areas F).

    Courtesy of MERCEDES-BENZ USA

12. Center roof paneling (1) (areas G).

    Courtesy of MERCEDES-BENZ USA