Tightening Procedure For Rear Propeller Shaft To Transfer Case - AR41.10-P-0050-17MSC
Model 167
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A |
PROPELLER SHAFT
| Number | Designation | Model 167 | ||
|---|---|---|---|---|
| BA41.10-P-1001-01F | Self-locking screw/bolt of propeller shaft at transfer case/adapter housing (to rear axle) | Stage 1 | Nm | 40 |
| Stage 2 | 90 | |||
Remove
- Mark position of rear propeller shaft relative to flange of transfer case in order to reproduce the factory installation position during installation.
- Remove screws (1 to 6) at transfer case and detach rear propeller shaft from transfercase.
Counterhold flange on transfer case with
retainer wrench.
Install
It is essential to observe the tightening procedure for the screws (1 to 6) securing the rear propeller shaft to the transfer case.
Otherwise, there are vibrations and noise development at high speeds.
- Align markings with each other.
- Tighten screws (3, 6) to initial torque of 10 Nm and mark.
- Tighten screws (1 to 6) in numerical sequence
.