LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2023 >> GLE450 >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Interior Equipment -- 167 Chassis >> Testing & Repair >> Remove/Install Crossmember Under Instrument Panel - AR68.10-P-1120ME

Remove/Install Crossmember Under Instrument Panel - AR68.10-P-1120ME

Model 167 

MODIFICATION NOTES

02.06.2020 Remove screw of the air duct on the front passenger side, added. Operation step 8  
G15038542Courtesy of MERCEDES-BENZ USA
G15038543Courtesy of MERCEDES-BENZ USA
Topical note  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
  Notes on safety-relevant components   AH00.00-Z-0019-01A
REMOVINGINSTALLING Remove/install     
1 Remove windshield wiper system.   AR82.30-P-0001ME
2 Remove instrument panel.   AR68.10-P-1000ME 
3 Remove steering column tube.   AR46.10-P-0400ME
4 Remove instrument cluster control unit.   AR54.30-P-7101ME
5 Remove center console.   AR68.20-P-2000ME 
6 Release and disconnect electrical connectors (1, 2) of the side air vent outlet air temperature sensors.    
7 Remove air duct (3) from the crossmember (6).    
8 Remove screw (4) and remove air duct (5) from the crossmember (6).    
9 Remove center air duct (8) from air conditioner housing (A32).    
10 Release and disconnect electrical connector from Bluetooth®/WiFi antenna 2 (A2/91).    
11 Release and disconnect electrical connector from Bluetooth®/WiFi antenna 3 (A2/161).    
12 Unclip electrical wiring harness (9) from crossmember (6) and place to one side.    
13 Remove the bolt (10). TORQUE SPECIFICATION Screw/bolt, instrument panel crossmember to transmission tunnel *BA68.10-P-1003-01B 
14 Remove grommet from the firewall and remove screw (7). TORQUE SPECIFICATION Screw/bolt, instrument panel crossmember to firewall *BA68.10-P-1001-01B 
15 Remove screws (11).    
16 Remove screw (12).    
17 Unscrew bolts (13). TORQUE SPECIFICATION Screw/bolt, instrument panel crossmember to A-pillar *BA68.10-P-1002-01B 
18 Remove crossmember (6). IMPORTANT Helper required.  
19 Install in the reverse order.    
INSTRUMENT PANEL

Number Designation Model 167
BA68.10-P-1001-01B Screw/bolt, instrument panel crossmember to firewall Nm 25
INSTRUMENT PANEL

Number Designation Model 167
BA68.10-P-1002-01B Screw/bolt, instrument panel crossmember to A-pillar Nm 25
INSTRUMENT PANEL

Number Designation Model 167
BA68.10-P-1003-01B Screw/bolt, instrument panel crossmember to transmission tunnel Nm 25