(Disposing Of Shock Absorber - OS32.25-P-0121-01GC)
MODEL 168, 169, 171, 172, 176, 203, 204, 207, 209, 212, 218, 231, 245, 246, 414.700
- Drill out shock absorber tube, approx. 45 mm (dimension A) from the lower shock absorber eye, using a drill (5 mm dia.) (gas escapes).
- Push piston rod all the way in and pull out again.
- Remove protective tube from shock absorber.
- Drill a hole in the shock absorber tube approx. 30 mm (dimension B) away from the top edge of the tube using a 5 mm dia. drill bit.
- Pump the shock absorber empty by pushing in and pulling out the piston rod several times.
Observe regulations governing disposal of hydraulic fluid.
- Dispose of shock absorber (scrap).