Outer A-Pillar Paneling Installation - Ar63.20-P-1223-03ME
Model 167
The following operation steps are to be performed on model 167.1 on the left side of the vehicle and must be performed analogously on the right side.
The higher-level service document as well as the safety information in the service document must be observed.
- Install, fit and fix in place A-pillar paneling (1).
- Drill rivet holes on A-pillar paneling (1) with Ø 6.7 mm (areas A, B).
- Drill rivet holes on A-pillar paneling (1) with Ø 6.7 mm (area C).
In the event of a complete repair job.
- Countersink rivet holes (area B).
- Remove A-pillar paneling (1).
- Deburr rivet holes on A-pillar paneling (1) and body on both sides.
- Remove drilling chips.
- Coat with zinc dust paint insides of those riveted joints that will not be bonded.
- Apply 2-component adhesive to body in crosshatched areas.
Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive.
- Install and fix in place A-pillar paneling (1).
- Rivet A-pillar paneling (1) with rivet Ø 6.5x12.5 (area D).
- Rivet A-pillar paneling (1) with countersunk-head blind rivet Ø 6.4x15.5 (area E).
- Rivet A-pillar paneling (1) with countersunk-head blind rivet Ø 6.4x17.0 (area F).
- Rivet A-pillar paneling (1) with countersunk-head blind rivet Ø 6.4x14.0 (area G).
- Rivet A-pillar paneling (1) with rivet Ø 6.4x12 (area H).
In the event of a complete repair job.
- A-pillar paneling (1)
(area J).
- A-pillar paneling (1)
In the event of a complete repair job.
- A-pillar paneling (1)
strike (area N).
- A-pillar paneling (1)
In the event of a partial repair.
- A-pillar paneling (1)
In the event of a complete repair job.
- Grind inert gas welds down flat.
- Solder surfaces on A-pillar paneling (1) in area of inert gas welds with body solder and smooth.