Remove/Install Side Airbag Sensor - AR91.60-P-0710ME

Model 167 

Fig 1: Side Airbag Sensor Components Location - Model 167 (Left Side Shown)

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicle 

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Move front seat at left or right to foremost position.
2	Clamp off ground line of on-board electrical system battery (G1).		AR54.10-P-0003ME
3	Remove lower trim from B-pillar.		AR68.30-P-4700ME
4	Release electrical connector (1) and disconnect.
5	Remove bolt (2) and remove side airbag sensor (3).	A complete and flat contact between the bush and the contact area on the vehicle is permanently required to ensure signal transmission is assured.
		Screw/bolt, frontal acceleration sensor to B-pillar	*BA91.60-P-1006-01R
6	Install in the reverse order.

AIRBAG

Number	Designation		Model 167
BA91.60-P-1006-01R	Screw/bolt, frontal acceleration sensor to B-pillar	Nm	8