Remove/Install Motor For Roller Sun Blind On Panoramic Sliding Roof - AR77.21-P-0490MFB
Model 243, 247
with code 413 (Panoramic sliding sunroof/glass roof)
Fig 1: Motor For Roller Sun Blind On Panoramic Sliding Roof Components Location - Model 247 With Code 413
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove headliner. | AR68.30-P-4300MFA | |
| 2 | Release electrical connector (1) and disconnect. | ||
| 3 | Remove screws (2) and remove panoramic sliding sunroof roller sunblind drive unit (M12/5). | ||
| 4 | Install in the reverse order. | ||
| Normalizing | |||
| 5 | Normalize roller sunblind with vehicle diagnosis system and perform teach-in process for automatic reversing function. | ||
| AD00.00-P-2000-06MFA |