Remove/Install Trim At C-Pillar - AR68.30-P-4490MFX
Model 243.6, 247.6
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove/install | |||
| 1 | Release side trim in rear on left and right until nut of seat belt end fitting (2) can be accessed. | AR68.30-P-4780MFX | |
| 2 | Remove nut from seat belt end fitting (2). | *BA91.40-P-1006-01X | |
| 3 | Unclip seat belt end fitting (2). | Fig 1 | |
| 4 | Unclip C-pillar trim (1) and extend downward out of the roof lining. | Otherwise the roof lining will be damaged. |
Fig 1 |
| 5 | Extend seat belt through seat belt outlet cover of C-pillar trim (1). | ||
| 6 | Install in the reverse order. |
SEAT BELTS/EMERGENCY TENSIONING RETRACTORS
| Number | Designation | Model 243 | Model 247 | |
|---|---|---|---|---|
| BA91.40-P-1006-01X | Screw/nut, seat belt end fitting/rear seat belt buckle to body | Nm | 35 | 35 |