Remove/Install Liftgate Wiper Motor - AR82.30-P-6550MFA
Model 177.0, 243, 247
Shown on model 177.0
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Topical note | Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | |
| Remove/install | |||
| 1 | Remove liftgate wiper arm. | AR82.30-P-6910MFA | |
| 2 | Remove center liftgate trim. | AR72.20-P-6618MFA | |
| 3 | Release electrical connector (1) and disconnect. | ||
| 4 | Remove screw/bolts (2). | ||
| 5 | Remove liftgate wiper motor (M6/4). | *BA82.30-P-1005-01Q | |
| 6 | Check grommet (3) for damage. | If damage is present, ↓ Replace grommet (3). |
|
| 7 | Install in the reverse order. |
WINDSHIELD WIPER
| Number | Designation | Model 177 | Model 243 | ||
|---|---|---|---|---|---|
| BA82.30-P-1005-01Q | Screw/bolt, wiper motor to rear-end door | M6 | Nm | 8 | 8 |
WINDSHIELD WIPER
| Number | Designation | Model 247 | ||
|---|---|---|---|---|
| BA82.30-P-1005-01Q | Screw/bolt, wiper motor to rear-end door | M6 | Nm | 8 |