Remove/Install Lamp Unit Holder - AR82.10-P-4740MFA
Model 118, 177, 243, 247
Shown on left front lamp unit (E1) of model 177
| Remove | |||
| 1 | Remove front lamp unit (E1, E2). | AR82.10-P-4733MFA | |
| Check | |||
| 2 | Check front lamp unit (E1, E2) for further signs of damage. | If there is a problem, ↓ replace front lamp unit (E1, E2). |
|
| 3.1 | Cut back residue of damaged holder (A, B, C) until corresponding repair holder (1) can be fitted. | If a repair holder (1) has not yet been installed. | |
| 3.2 | Remove screws (3) of damaged repair holder (1) and remove respective repair holder (1). | If a repair holder (1) has already been installed. | |
| 4 | Clean and deburr repair area on front lamp unit (E1, E2). | ||
| Install | |||
| 5.1 | Align setting screw (2) of new repair holder (1) to match setting screw (2) of damaged holder (A, B, C). | If a repair holder (1) has not yet been installed. | |
| 5.2 | Align setting screw (2) of new repair holder (1) to match setting screw (2) of damaged holder (1). | If a repair holder (1) has already been installed. | |
| 6 | Position respective repair holder (1) on front lamp unit (E1, E2) and tighten screws (3) at designated holes. | ||
| 7 | Install front lamp unit (E1, E2). | AR82.10-P-4733MFA |