Remove/Install Trim At C-Pillar - AR68.30-P-4490MFB

Model 243.7, 247.0/7 

Shown on model 247.7 on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove rear shelf.
2	Fold left or right rear seat forward.
3	Unclip cover (1).	Long wedge	Fig 1
4	Remove edge guard in working area.	: Ensure that edge guard is correctly positioned.
5	Unclip trim (3).	Long wedge	Fig 1
6	Release and disconnect electrical connector on left load compartment lamp (E18/5).	When removing left trim (3).
7	Remove trim (3).	: Insert cover (1) into trim (3) with associated clip.
8	Unclip left load compartment lamp (E18/5) and remove.	When replacing left trim (3).
9	Install in the reverse order.

Fig 1: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA