Remove/Install Side AIRBAG Sensor - AR91.60-P-0710MFA

Model 118, 177, 243, 247 

Shown on model 177 on left side of vehicle 

Fig 1: Side Airbag Sensor Components Location - Model 247 (Shown On Model 177 Left Side)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Switch off ignition and store transmitter key outside of transmitter range (min. 2 m).
2	Detach ground line of on-board electrical system battery.		AR54.10-P-0003MFA
3	Move front seat at left or right to foremost position.
4	Remove lower B-pillar trim.		AR68.30-P-4705MFA
5	Release electrical connector (l) and disconnect.
6	Unscrew screw (2) and remove side airbag sensor (3).	: Complete, flat contact between the bushing and the contact area on the vehicle is necessary at all times to guarantee signal transmission.
		Screw/bolt, frontal acceleration sensor to B-pillar	*BA91.60-P-1010-01Q
7	Install in the reverse order.