Remove/Install Window AIRBAG - AR91.60-P-0693MFA

Model 118, 177, 243, 247 

Fig 1: Window Airbag Components Location - Model 247 (Shown On Model 177.0 Left Side)

Courtesy of MERCEDES-BENZ USA

Shown on model 177.0 on left side of vehicle 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts.	AS91.00-Z-0008-01A
Notice	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on safety-relevant components		AH00.00-Z-0019-01A
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Detach ground line of on-board electrical system battery.		AR54.10-P-0003MFA
2	Remove headliner.	Model 118.3, 177.1/9	AR68.30-P-4300MFV
		Model 118.6	AR68.30-P-4300MFD
		Model 177.0, 243, 247	AR68.30-P-4300MFA
		Lower roof lining on required side only far enough to gain access to the fastening points of the window airbag (1).
3	Insert pliers through openings (arrows A) to press tabs (arrows B) together and then remove retaining clips (4).
4	Release and disconnect electrical connector (2) from left window airbag squib (R12/22) or right window airbag squib (R12/23).	Removal lever	Fig 2
5	Remove bolt (3).	Bolt, window airbag unit to roof frame	*BA91.60-P-1005-01Q
6	Remove window airbag (1) and place on a suitable surface.	Handle window airbag (1) carefully. Otherwise, the remaining interior equipment or paint may be damaged.
7	Install in the reverse order.
	Check
8	Check Supplemental Restraint System (SRS) using vehicle diagnosis system.	If the window airbag (1) is replaced.
			AD00.00-P-2000-06MFA

Fig 2: Identifying Removal Lever (203 589 04 33 00)

Courtesy of MERCEDES-BENZ USA