Remove/Install Side Paneling In Trunk - AR68.30-P-4800MFB

Model 243.7, 247.0/7 

Shown on model 247.7 on left side of vehicle 

except code B01 (48V technology) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove left and right C-pillar trim.		AR68.30-P-4490MFB
2	Remove load compartment floor support.	Model 243.7	AR68.80-P-0025EQA
3	Remove rear-end center section trim.	Model 247.0/7	AR68.30-P-4786MFV
4	Remove edge guard in working area.	Ensure that edge guard is correctly positioned.
5	Remove tie-down eyes (2).	Screw/bolt for tie-down eye	*BA68.50-P-1001-03I
6	Remove expansion rivets (3).	Dismantling tool	Fig 1
7	Release trim (1) until the electrical connector of the trunk socket (X58/12) is accessible.	Model 243.7, 247.0/7 with code U35 (12 V socket in load area) Only on left-hand side of the vehicle.
8	Release and disconnect electrical connector of the luggage compartment socket (X58/12).	Model 243.7, 247.0/7 with code U35 (12 V socket in load area) Only on left-hand side of the vehicle.
9	Remove trim (1).	Ensure that the trim (1) is inserted correctly in the adjacent trims. Damage to adjacent trim can otherwise occur.
10	Remove luggage compartment socket (X58/12).	Model 243.7, 247.0/7 with code U35 (12 V socket in load area) When replacing trim (1) at left side of vehicle.
11	Install in the reverse order.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA