Panic Alarm System (PAS), Basic Function - GF82.25-P-9902A
Model All (CAR)
with code Z22 (Panic alarm system)
Overview
This document contains information on:
- General
- Function requirements
- Function
- Trigger alarm
- Alarm output
- Switch off alarm
- Intercom system
General
In the event of danger, the panic alarm system enables vehicle occupants to be secured against external access. A visual and acoustic alarm calls attention to an emergency situation. It is also possible to use an intercom system to contact people outside the vehicle.
Function requirements
- Loudhailer mode terminated (only for trigger and switch off alarm)
- Alarm triggered (only for alarm output)
- Terminal 15 ON (with voice communications from outside to inside)
Function
Trigger alarm
The following buttons trigger the alarm:
- "Trigger/reset alarm" button on special protection operating unit in front center console
- "Trigger emergency alarm system in rear passenger compartment" button
The statuses of the buttons are read in directly by the special vehicle multifunction control unit (SVMCU) and forwarded to the PAS and special signaling system control unit. The PAS [GAS] and special signal system control unit then triggers the alarm.
Alarm output
The alarm output is performed using an optical and acoustic alarm. The vehicle is also locked and the fresh air/recirculated air flaps are closed.
Optical alarm:
During a visual alarm output, the special-purpose vehicle multifunction control unit (SVMCU) sends the "Alarm light functions" request over the vehicle interior CAN to the front SAM control unit. As a result, the hazard warning light system flashes at increased flashing frequency (alarm flashing) and the high beams flash on and off.
Acoustic alarm:
The acoustic alarm is emitted through the exterior PAS [GAS] speakers mounted in the front area of the vehicle.
The frequency is generated by a sound generator integrated into the PAS [GAS] and special signal system control unit, and sent directly to the PAS [GAS] speakers.
Lock vehicle:
To secure the vehicle against access from the outside the central locking system (CL [ZV]) is locked when an alarm is triggered. The "Unlock vehicle" key function is disabled and the vehicle can only be unlocked from the outside using the emergency key.
All doors are always locked. Even if a door is still open the remaining doors are still locked. If the door is closed, it is then locked.
Only an open driver's door is not locked (driver lockout protection).
The CL system cannot be unlocked from the inside (electrically using the CL internal operation pushbutton switch) or wirelessly as long as the special-purpose vehicle multifunction control unit (SVMCU) is sending the "Lock CL" request over the vehicle interior CAN. In the event of an alarm, manual opening of the individual vehicle doors from the inside or opening from the outside using the emergency key in the driver's door lock is also possible.
If one of the doors is in the first lock notch, the door is fully closed by the power closing function, and then locked.
Close air recirculation flap:
The air recirculation flap is closed to ensure that unpleasant odors or pollutants do not enter from the outside. In the event of an alarm, the special-purpose vehicle multifunction control unit (SVMCU) sends the "Switch on recirculated air" request over the vehicle interior CAN to the climate co ntrol unit.
The "Switch on recirculation" request is sent for a limited period only. During this period, the air recirculation flap can be manually opened using the air-recirculation mode button on the air conditioning control panel.
Switch off alarm
The alarm can be switched off by pressing the full-duplex intercom system (speak) button in the Guard operating unit or after a minimum alarm time of approx. 3 seconds by pressing one of the alarm buttons again. The active alarm functions are deactivated. The operating conditions of the standard components, such as, e.g. the exterior lights and the CL system, are active again and can be operated as usual.
The "Switch on recirculation" request is sent for a limited period only. During this period, the air recirculation flap can be manually opened using the air-recirculation mode button on the air conditioning control panel.
Control code 89Z is used to limit the alarm duration. The alarm is switched off after no more than 30 seconds.
Intercom system
The intercom system can be used to make contact with the outside of the vehicle or to listen to external noise in the vehicle. In both cases, an active audio output (e.g. radio) is muted.
Voice communications from outside to inside:
The intercom system button (Listen) in the Guard operating unit activates the intercom system. Noises outside the vehicle are recorded by the left outside mirror PAS [GAS] microphone and the right outside mirror PAS [GAS] microphone. The PAS and special signaling system control unit reads in the signals from the outside mirror PAS microphones directly, amplifies them and actuates the speaker in the instrument panel.
Voice communications from inside to outside:
Operation of the intercom system button (Speak) in the Guard operating unit switches off the outside mirror PAS [GAS] microphones, and the voice communication function from the inside outwards is then activated. The acoustic signals are picked up by the interior microphone and read in directly by the PAS and special signaling system control unit. The PAS [GAS] and special signal system control unit amplifies these signals and sends them through a direct output to the PAS [GAS] outside speaker.
Operating the intercom system button (Speak) in the Guard operating unit causes a triggered alarm to be terminated.
| Function schematics | |||
| Function schematic for panic alarm system (PAS) - Trigger alarm | Model 223 with code Z22 (Panic alarm system) | PE82.25-P-2504-97A | |
| Function schematic for panic alarm system (PAS) - Communication | Model 223 with code Z22 (Panic alarm system) | PE82.25-P-2505-97A | |
| Further basic functions | |||
| Central locking system, basic function | GF80.20-P-9900A | ||
| Actuate driving lights, basic function | GF82.10-P-1013A | ||
| Actuate turn signal light, basic function | GF82.10-P-1023A | ||
| Special vehicle multifunction control unit, basic function | Model all (CAR) with code Z22 (Panic alarm system) with code Z90 (Multifunctional control unit for special functions) except code 965 (Taxi/rental car - electrical pre-installation) | GF82.25-P-9892B | |
| Air-recirculation mode, basic function | GF83.40-P-1002A | ||
| Component descriptions | |||
| 12 V on-board electrical system fuse and relay module, component description | Model 223 with code Z22 (Panic alarm system) | GF54.15-P-0006A | |
| Panic alarm system (PAS) control unit, component description | Model 223 with code Z22 (Panic alarm system) | GF82.25-P-0021A | |
| Emergency alarm system activation button, component description | Model 223 with code Z22 (Panic alarm system) | GF82.25-P-2208A | |
| Speaker, component description | Model 223 with code Z22 (Panic alarm system) | GF82.62-P-4211A | |
| Microphone component description | Model 223 with code Z22 (Panic alarm system) | GF82.70-P-4140A | |
| Outside mirror, component description | Model 223 with code Z22 (Panic alarm system) | GF88.79-P-4003A |