Remove/Install Front Stabilizer Bar Linkage - AR32.35-P-3330FRA

Model 257 with code M005 (Vehicles with 4MATIC/all-wheel drive) 

Model 290 

Shown on model 257 

Fig 1: Front Stabilizer Bar Linkage Components Location - Model 257 With Code M005

Courtesy of MERCEDES-BENZ USA

Notice	Notes on handling, transport and storage of ceramic brake disks		AH42.10-P-9406-13A
Notice	Notes on handling, transport and storage of composite brake disks		AH42.10-P-9406-12LF
Notice	Notes on self-locking nuts and bolts		AH00.00-P-0001-01KOA
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Remove front wheel.		AR40.10-P-1102A
2	Unbolt nut (2).	Nut, torsion bar linkage to steering knuckle	*BA32.35-P-1006-02B
3	Remove torsion bar linkage (1) from stabilizer bar (3).	Torsion bar linkage to stabilizer bar	*BA32.35-P-1005-02B
4	Pull torsion bar linkage (1) out of steering knuckle (6).	The guide pin (4) must engage in the cutout (5) of the steering knuckle (6).
		Otherwise, the steering knuckle (6) will be damaged.
	Check
5	Check ball heads of torsion bar linkage (1) and their boots for condition and damage.	In the event of a problem, ↓
		replace torsion bar linkage (1).
6	Install in the reverse order.