Remove/Install Stabilizer Bar At Front Axle - AR32.35-P-2200FR
Model 257 except code M005 (Vehicles with 4MATIC/all-wheel drive)
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Remove front axle | AR33.10-P-0100FR | |
| 2 | Remove both torsion bar linkages (2) from stabilizer bar (1) | *BA32.35-P-1002-02B | |
| 3 | Unscrew screws/bolts (3), take off mounting bar (4) and remove stabilizer bar (1) to the side | *BA32.35-P-1001-02B | |
| 4 | Install in the reverse order | ||
| 5 | Perform wheel alignment check | AR40.20-P-0200FR |
FRONT AXLE STABILIZER BAR
| Number | Designation | Model 257 except code M005 (Vehicles with 4MATIC/all-wheel drive) | |
|---|---|---|---|
| BA32.35-P-1001-02B | Screw, stabilizer bar to longitudinal member | Nm | 70 |
FRONT AXLE STABILIZER BAR
| Number | Designation | Model 257 except code M005 (Vehicles with 4MATIC/all-wheel drive) | |
|---|---|---|---|
| BA32.35-P-1002-02B | Nut, torsion bar linkage to stabilizer bar | Nm | 130 |