Remove/Install Brake Fluid Reservoir - AR42.10-P-0301FR
Model 257
Model 290
Shown on model 257
| Risk of poisoning from swallowing Brake fluid. Risk of injury from skin and eye contact with Brake fluid | Only pour Brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling Brake fluid. | AS42.50-Z-0001-01A | |
| Topical note | Notes on repairs to Brake system | AH42.00-P-0003-01A | |
| Topical note | Brake fluid notes | AH42.50-P-0001-01A | |
| Notes on safety-relevant components | AH00.00-Z-0019-01A | ||
| Remove | |||
| 1 | Remove cover over Brake fluid reservoir (1). | ||
| 2 | Disconnect electrical connection (2). | ||
| 3 | Unscrew cap (3) and remove sieve from Brake fluid reservoir (1). | ||
| 4 | Extract Brake fluid from Brake fluid reservoir (1). | ||
| 5 | Remove locking pin (4). | ||
| 6 | Remove Brake fluid reservoir (1) from master Brake cylinder (5) and seal connections with suitable stop plugs. | Collect Brake fluid which runs out with an absorbent rag. Otherwise, the paint will be damaged. |
|
| Fig 2 | |||
| Install | |||
| 7 | Remove stop plugs from connections and attach Brake fluid reservoir (1) to master Brake cylinder (5). | ||
| 8 | Install locking pin (4). | ||
| 9 | Fill Brake fluid reservoir (1) with Brake fluid. | ||
| AP42.10-P-4210B | |||
| 10 | Insert sieve into Brake fluid reservoir (1) and screw on cap (3). | ||
| 11 | Connect electrical connection (2). | ||
| 12 | Check area around Brake fluid reservoir (1) for leak tightness. | ||
| 13 | Install cover over Brake fluid reservoir (1). |