Install Cross Member And Weld In - Ar64.20-P-1060-03FR

Model 257, 290 

Additional information can be found in the superordinate service document.

The safety information in the superordinate service document must be observed.

1. Install, fit and fix in place crossmember (2).
2. Crossmember (2) (areas A).

   The operation step is shown on the left side of the vehicle and must be performed in the same way on the right side.

   Courtesy of MERCEDES-BENZ USA

   Courtesy of MERCEDES-BENZ USA

3. Install support angle (3), fit, and fix in place.
4. Support angle (3) (area E).