Remove/Install Lower Engine Stabilizer Mount - AR22.10-P-1155MFG
Engine 139 in model 118, 177, 247
Shown on model 177
Fig 1: Lower Engine Stabilizer Mount Components Location - Model 118 With Engine 139 (Shown On Model 177)
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Remove/install | |||
| 1 | Remove lower engine compartment lining. | AR61.20-P-1105MFR | |
| 2 | Remove screw (1) | *BA22.10-P-1008-03P | |
| 3 | Remove screws (2) and remove bottom engine stabilizer mount (3). | *BA22.10-P-1009-03P | |
| 4 | Check elastomer bearing of the bottom engine stabilizer mount (3) for damage and wear. Evaluation of elastomer bearings |
If there are problems: ↓ replace bottom engine stabilizer mount (3). |
AH00.10-P-0001-01A |
| 5 | Install in the reverse order. |
ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)
| Number | Designation | Model 118, 177, 247 | ||
|---|---|---|---|---|
| BA22.10-P-1008-03P | Screw, engine carrier engine stabilizer mount at bottom to front axle carrier | Stage 1 | Nm | 106 |
| Stage 2 | ∠° | - | ||
ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)
| Number | Designation | Model 118, 177, 247 | |
|---|---|---|---|
| BA22.10-P-1009-03P | Screw, lower engine stabilizer mount to engine carrier/electric drive | Nm | 106 |